TM6 INSTALLATION & OPERATING INSTRUCTIONS

If paying directly with Visa or MasterCard- Use Checkout

 

TM6 CELSIUS

TM6 with mounting screws, heat sensor with 1.8 metre lead. Installation Instructions. (Reads in Celsius)

AU $229.00 plus $12 postage world wide

TM6 FAHRENHEIT

TM6 with mounting screws, heat sensor with 1.8 metre lead. Installation Instructions. (Reads in Fahrenheit)

AU $229.00 plus $12 postage world wide

Accessories below can only be purchased with a TM6. You must add them to the cart if you require them.

   

12 volt Fuel Solenoid with barbs. We only sell this 12v solenoid, however it can be used on 24v systems when the voltage reducer below is used. It suits small to medium sized engines. (Only available when purchased with a TM6)

Fuel Solenoid is required if your engine does not already have an electrical method of stopping the engine. It goes between the tank & the fuel pump (pump does NOT need re-priming after stopping)

AU $65.00

24 to 12 volt Voltage Reducer for the above solenoid when used on 24v systems. Note: The TM6 can operate on 24v, however the 12v solenoid above cannot. (This reducer is only available when purchased with a TM6 & the 12v fuel solenoid)

AU $25.00

Murphy Hi/Low 150 psi Water Pressure Switch with 3m connection kit (panel mount style only) (Only available when purchased with a TM6)

Water pressure switch is a third method of stopping irrigation pumps should the pipe burst or pump loose prime.

AU $185.00